8.8 Truss BRIDGE

THIS PART REQUIRES WELDING AND GENERALFABRICATION SKILLS. ONLY COMPETENT WELDERS SHOULD ATTEMPT TO INSTALL THIS PART.

Tools Required :

Safety Glasses, Gloves, , Socket Set, Wrenches, Wheelchocks,  Cutting Tool of your choice(Sawzall, Grinder, plasma, cutting torch) Welder.

Step 1:

Inventory that you have all of the parts for your order If you are missingparts or have incorrect parts contact Artec Industries Immediately @(855)-278-3299  M-F from 8am-5pm MST   If it is after those hours please EmailSales@Artecindustries.com

Step 2:

Place wheel chocks at front wheels on vehicle ,  Jack up the rear of the vehicle and set securelyon jack stands . 

Step 3: 

Set TR8804 pinion bridge against the truss and mountingflange on the axle. Bolt the flange to the axle if you are able to (Depending on your pinion angle you may need to trim thebridge to fit)    Weld the bridgeto the truss . 

Step 4:

Raise vehicle and lower off of jack stands. 

 Check bolts for tightness after 50miles re tighten if needed