Raised Trackbar Bracket for TJ Front Axle
NOTE: This kit requires general welding and fabrication skills. Welding should only be done by a competent welder. Artec Industries implies no guarantees or warranties and is not liable for improper installation.
This part requires welding and fabrication skills ifyou are not confident in your abilities please take to an Off-road shop toinstall this part.
Warning: This part does not work with an off the shelf Track bar A custom Track bar will need to be fabricated.
Tools Required :
Safety Glasses, Gloves, Socket Set, Wrenches, Jack, Jack stand, wheel chocks, Cutting Tool ofyour choice (Sawzall, Grinder, plasma, cutting torch) Welder.
Inventory that you have all of the parts for your order Ifyou are missing parts or have incorrect parts contact Artec IndustriesImmediately @ (855)-278-3299 M-F from8am-5pm MST If it is after those hoursplease Email Sales@Artecindustries.com
Place wheel chocks at the rear of the vehicle , Use a jack to lift the front of the vehicle andset the front axle securely onto theJack stands.
Remove your current track bar from the vehicle.
Use a wire wheel or flap disk to clean and prep the axletubes for welding .
Insert TJ3013-2 tab into keyway cut out on partTJ3013-1. Once the tab is inserted intothe keyway insert your trackbar joint into the bracket to adjust mounting widthand tack weld the inner plate into place .
Remove your track bar from the bracket and fully weld theinner part of the bracket into position.
Set track bar mount into position on the axle you shouldhave a measurement of 4" betweencenter of OEM bracket bolt hole to center of lower bolt hole on the Artec bracket. Weld track bar bracket into position.
Prime and Paint the bracket we get the best results withrustolem paint .
Measure the distance from Frame side track bar mount todesired mounting hole bracket and fabricate a new track bar, Once the track bar is fabricated install it intothe vehicle
lower the vehicle offof the Jack stands and take to an alignmentshop to have an alignment is performed to ensure the geometry is correct.