JK Rear Frame UCA 3-link bracket

Warning: Installing this product requires Welding and Fabrication skills, If youare not confident in your abilities to complete this task please have thisinstalled at an qualified off-road shop .

 Tools required:  Safetyglasses,  grinder, Welder, Weldingblanket ,  Jack, Jack stands, WheelChocks.

Step 1:

Please take inventory of parts,  Call Artec Industries Immediately if you have incorrect ormissing components @ (855) 278-3299 M-F 8am-5pm MST  If outside of those hours please send us anEmail at Sales@ArtecIndustries.com

Step 2:

Place wheel chocks at the front wheels of the vehicle,     Use a Jack and lift the rear of thevehicle off of the ground.  Set Jack  stands under the rear axle .

Step 3: 

Hang a welding blanket over the rear driveshaft to protectit from debris and welding spatter .  

Step 4:

Using a grinder or wire wheel  remove any paint or debris from the crossmembers under the rear of the Jeep Once area is prepped for welding hold theJK2022 bracket into position using the 2 alignment holes in the cross memberand bracket to properly locate the bracket and weld it into place .   

Step 5: 

After the bracket is welded into place, Apply  Primer and Paint the cross member andbracket  then remove the welding blanketfrom the driveshaft .    

Step 6:

Raise the vehicle up off of the jack stands and remove themfrom the vehicle then lower the vehicle to the ground .