This part requires welding and fabricationskills if you are not confident in your abilities please take to an Off-roadshop to install this part.

 Warning: This part does not work with an off the shelf Track bar  A custom Track bar will need to be fabricated.

 Tools Required :

Safety Glasses, Gloves, Socket Set, Wrenches, Jack, Jack stand, wheel chocks, Cutting Tool ofyour choice (Sawzall, Grinder, plasma, cutting torch)  Welder.

 Step 1:

Inventory that you have all of the parts for your order If you aremissing parts or have incorrect parts contact Artec Industries Immediately @(855)-278-3299  M-F from 8am-5pm MST   If it is after those hours please EmailSales@Artecindustries.com

 Step 2:

Place wheel chocks at the rear of the vehicle ,  Use a jack to lift the front of the vehicleand set  the front axle securely onto theJack stands.

 Step 3: 

Remove your current track bar from the vehicle.

 Step 4:

Use a wire wheel or flap disk to clean and prep the axletubes for welding .

 Step 5:

Insert Br1139-2 tab into keyway cut out on partBr1139-1.  Once the tab is inserted intothe keyway insert your track bar joint into the bracket to adjust mountingwidth and tack weld the inner plate into place .

 Step 6: 

Remove your track bar from the bracket and fully weld theinner part of the bracket into position.

 Step 7:

Set track bar mount into position on the axle , Weld trackbar bracket into position.

 Step 8:

Prime and Paint the bracket we get the best results withrustolem paint .

 Step 9:

Measure the distance from Frame side track bar mount todesired mounting hole bracket and fabricate a new track bar,  Once the track bar is fabricated install itinto the vehicle. Lower the vehicle off of the Jack stands and take to analignment shop to have an alignment is performed to ensure the geometry iscorrect.

Check bolts and nuts for tightness afterdriving about 50 miles if they are loose tighten the bolts.